- sweep picking problems
- blah blah blah
- Some Cool Techniques
- Thin neck
- Can't wait for my new Schecter!
- The tone knob
- Schecter strat POTS
- C-1 Elite
- Tech/Repair issue
- Pickups and wiring style
- Diamond Bass pickups
- Manuals and Support
- Schecter Inlays
- Proper set-up for Tempest Custom
- Schecter Stiletto Custom-4 fret buzzing
- Omen 6 size
- Black Hardware
- Old Stiletto Studio 5, different configuration
- String Barrells
- Some useful info about Schecters and modding them
- Put some Schecter SuperRock IIs in my guitar (picture)
- issue with keeping guitar in tune
- A solution I found for ClipLock straps when not in use (pic)
- Installing Schaller Strap Locks/Stripped Screw Hole
- EMG 18 Volt Mod on Hellraiser?
- Replacement Pickup Rings
- New locking Bridge of my C1.
- Drop tuning going back and forth
- F-Spaced Pickups on a C-1 plus
- What do you use to treat and condition your fingerboards?
- Truss Rod
- Have a licensed Floyd Rose on your guitar? Read this.
- Cables....
- Guitar Polish?
- Pickup questions
- Fret Buzz
- Instrument ranges
- Pickup height that you find works best
- Scuff marks: repolishing?
- what schecter to buy?completely newbie
- are my strings improperly winded?
- String rattle and fret buzzing
- Replacing Passive Pickups with Active Ones
- String Info
- Loose pickup
- What dr strings should i get?
- Action adjustment
- C-1 Nut Width
- Upgrades to an Omen 6
- Original Floyd Rose or Schaller Floyd Rose
- Long Scale guitars
- Neck finishes
- Scales?
- Fret buzz, pt. 2
- EMG-EXG
- changing strings question
- Intonation/Action
- The world is in extreme danger...
- where can I get these?
- Good strap locks?
- will going from 10-46 strings to 9-46 hybrid strings
- Installing Blackouts into a passive C-1
- New information I just obtained from GraphTech
- JB Humbucker with different Fingerboard?
- average time till unplayable fret wear
- setup changes from 10's to 9's?
- Pearly Gates Same as LP sound?
- No output sound, just hum
- Shecter C-1+
- feedback problem
- Tremolo Arm Loose
- Something every guitarist should be aware of...
- New mods to my C-1 Elite (with pictures). Opinions?
- My beloved Ivory is falling apart... (pictures)
- popping strings
- Schecter Grovers?
- changing string gauge
- truss rod adjustment
- I hope I didn't screw up big time here...
- Tonepros by Gotoh
- EMG's (81/85) or Seymour Duncan Blackouts for my She-Devil?
- Help! Harmonic on one fret, one string
- Schecter C-1 Classic Coil Split
- C1-FR Duncan Design HB-105 Hissing Noise
- Fret buzz on low E string
- The wonders of a little mineral oil =)
- Schecter C-1 E/A pick-up humming problem
- Swapping pickups around in search of perfect tone (input?)
- Strings falling off tonepros bridge.....help!
- Schecter c-7 hellraiser body hit
- Need help with guitar input jack
- HB-102 hotter than the Seymour?
- Fretboard Care/String Guage Help!!
- Stupid FR Question
- Setup specs for C1 elite
- How do you make your frets shine again?
- In or Out???
- C-1+ Buzz
- help me out
- The truth about Seymour Duncans Blackouts
- Several questions
- Schecter SuperRockII
- Orange Drop Caps
- C-1 E/A tone pots
- Hi! - my mew guy questions
- Schecter C1 Classic pots...
- bolt on to set neck
- Paint jobs
- Question about a FR
- The EMG's on my Hellraiser c-1 FR.
- Warning to people near Atlanta
- Fretboard Wear
- schecter wins award for unreliability
- Making the move to actives...
- Schecter C-1 Classic help!
- Switching to Blackouts?
- Original Floyd Rose Tension Help
- Check your pots
- Finished the mods to my Loomis.
- Question about specific locking tuners
- need help with my damien
- FYI:How to take mud out of Duncan JB / Duncan Designed HB102
- Duncan Designed HB-105 active wiring
- Upgrading Pickups on my Gryphon
- Omen-6 pickups/tone pot
- Strap Butten Problem
- Pickup installation/Floyd Rose replacing!
- Help: Schecter C-1 Hollowbody
- Want to black out the C-7 ATX, what bridge fits it?
- HB102s (duncan designed) harsh top end?
- cleaning tips
- bareknuckle pickups in my c-1
- String ground on a tune-o-matic...how to?
- Guitar sounds muddy tuned to CGCFAD (was set-up)
- Wiring Diagram
- 3-Way Switch
- Low E string slipping out of bridge saddle
- How close should the pickups be adjusted...
- hybrid gauge strings
- adjusting intonation with a Korg Chromatic Tuner CA-30
- Gonna go with some 8s for a change
- Duncan Designed HB-102/FG-101 replacement
- Phase II backward compatibility?
- Adjustments of Schecter Terry Corso model
- problem with c-1 fr help please!?
- Blackjack issue with G and B strings
- 1C - molded case - Diamond Series
- String Gauge for C Tuning
- 24v mod pack for actives.
- High quality replacement for licensed Floyd Rose
- tuners: gotoh vs schaller vs grover
- Floyd Rose - string change
- Sweet jesus! Splittable 707s!!
- need help with the damien, again
- Tuning Stability in C
- Wires on a Humbucker
- Schecter C-1 classic pickups
- Changing dual volume controls to single?
- 3 way pickup toggle switch on C-1 Exotic
- Which size allen wrench to adjust C-1 Blackjack's truss rod?
- C-1 Neck Radius
- My intonation screw ... screw up !
- 18v Mod - The British Way
- C-1 Blackjack ATX FR Floyd Rose & now other misc Q's =)
- Pickguard for Ultra Bass
- Pickup selector question
- Tuner changing
- C7 (L) FR Specs
- Help with Damien FR
- D'OH! Chipped My Guitar!
- Fret Buzz
- tremel-no experiences??
- Schecter Synyster Custom Tone Problems
- And now for something completely different...
- Will an OFR fit in place of the licensed ones?
- Fret polishing...
- Hellraiser Fret sizes
- How to clean Ebony fret boards?
- EMG Question
- Sound
- Heads up C-1 Classic owners!
- Seymour Duncan Blackouts....
- C-1 Hellraiser FR Radius?
- S-1 RAF Spitfire setup
- Noob and an Omen 6
- Looking for some badass pickups? Look no further.
- Boss NS-2 Noise Suppressor settings?
- CUSTOM HANDWOUND PICKUPS
- Bridge
- Rhythm
- string lock for schecter 80ies tremlock?
- Is it bad...
- Thinking about Les Trem Tremolo for my S1...advice/opinions?
- Just switched strings... wow
- Strings
- c-1 classic tone control
- Neck options
- fixing string scratches
- neck radius
- Custom pickguard help
- wanted vintage schecter schematic for strat style
- Omen 6 neck crack
- Baritone problem...
- Replacing 707s with passives
- 3-way switch wiring screwed up on 006 Deluxe. Pls help
- What size truss rod wrench for a Dallas era Schecter neck?
- Trembucker on my Baritone Blackjack
- POD Studio GX?
- Tremolo problem. Please help.
- Fret buzz on open string? Am I screwed?
- Blackjack pup change
- How hard is it to change pickups?
- What is the Difference Between AHB-1 Blackouts and AHB-2s?
- How Hard Is It To Swap EMG Pickups With Seymour Duncan Black
- Can you make your EQ pedal sound like a single coil?
- Wiring/knobs incorrect on basses?
- String Change Tutorial
- Tuning Peg on New Blackjack is not seated all the way..
- Help With "New" Schecter
- (Something had to go wrong) Resonant truss rod
- New project guitar! C-1+
- How do licensed FRs hold tune?
- Stiletto Studio..not active pickups????
- floyd rose problems
- Duncan Designed HB-102 question
- Will 1000k pots = Brighter Invader in all-mahogany axe?
- Schecter C-1 Hellraiser fret buzz
- Odd problem on E string
- neck problems
- coil tapping my new tempest
- Help With tone please
- Tonal differences between EMG 81tw and regular 81?
- Omen 6 Nut Replacement - Open String Buzz
- passive to active upgrade
- My tempest
- Guide: From active to passive pickups in a 7-string
- Anybody know setup Factory settings for Schecters?
- Damien Quick D/C pick ups
- having trouble with the g spot..i mean string
- Tremolo problem
- Blackjack Bridge replacement
- Way to repair minor scratches?
- STRING CHANGE ON FLOYD ROSE?
- Tuner hole dimension
- Best Strap Locks?
- String Stuck under fret HELP!!!
- Bridge humbucker issue
- Grover Tuning Heads
- Finger-ease ?
- TONER's TUTORIALS